To move, rotate, or scale points, or to change
point-specific properties, the points must first be selected. There are several
ways points can be selected, depending on what you want to do.
To select points one at a
the cursor over the point.
2. Click to
select the point. All other points will be automatically deselected.
3. If you
want to select another point, repeat the above steps while pressing and holding
To select points using a
and/or zoom out until the points you want to select are fully inside the view.
and drag to draw the selection rectangle. The rectangle must fully surround the
points you want to select. When you release the left mouse button, the points
will be selected.
To select all points in the
Edit > Select all.
points in the object will be selected.
To deselect points one at a
the cursor over the point you want to deselect.
and hold Shift.
3. Click to
deselect the point. Each time you click the point, its selection status will
toggle on or off.
for each point you want to deselect.
To deselect all points:
Edit > Select None.
- OR -
the cursor anywhere but over a point (the cursor will change to a small
2. Click to
deselect all points.
To undo any selection change, click Undo.
Unselected points are yellow; selected points are red. The
following is an example of a deck with two selected points.
Inserting & Deleting Points
Using Automatic Dimensions
Undoing and Redoing